The Original VapCap Water Wand
4/20 Special! Buy one waterwand, receive THREE!
- Ever wish your VapCap were a desktop vape?
- Need a VapCap vong?
- Wish you could repeatedly use your VapCap with waterpipe and friends, but your VapCap gets too hot?
- Looking for a cost effective piece?
Kit Comes With :
- 14mm Wand that fits VapCap tip.
- 4 x O-Rings
Optionally With :
- 18mm/14mm Reducer (if your water pipe is 18mm Female Joint)
- Keck clip to hold reducer to wand. (color varies)
In addition to this kit, all you need to make a great VapCap desktop vape:
- The VapCap Cap:
- The VapCap Tip: (Stainless Steel tips work too, but DynaVap doesn't list them separately yet).
- A Water Pipe:
- Either 14mm or 18mm Female Joint.
- Why not add a Stainless Steel tip and VapCap Cap to your order (Adds $35)
- Please leave a comment with your order if you would like to use the wand with a Titanium tip.
- If no comment is left with your order, the wand sent will be sized for a Stainless Steel tip.
Ti Fitment Note: Recently, it's been discovered that there are two different Ti Tip Sizes.. One that is 8mm (newer) and one that is 7.9mm or slightly smaller. Since we do not have your Tip for a size verification at DDaveMods, please understand that you are responsible to know which Ti tip you have before requesting the Ti size. To help you determine the right size, DDave Mods would like to let you know that most hardware stores have a "bolt sizing template". You can bring your tip to the store and see if it fits in the 8mm template. If it fits, you'll be good to go with an SS tip. If the 8mm template opening is too large for your tip, with orings installed, then you should request the Ti water wand.