The DDave iSpire IH Mod
Looking to use your iSpire Wand as a VapCap heater but wish it were just easier?
Look no further. The DDave iSpire IH Mod is here!
What is it? It's a specially designed glass insert surrounded by a custom silicone sleeve. The glass insert is designed with an optimum insertion depth already dialed in, so you simply install and use. NO TINKERING REQUIRED!
The mod comes to you pre-assembled and ready to install. To do so, place your wand upside down, on a towel, on a flat surface. Take a drop of water and moisten the silicone sleeve. (Yes, 1 drop. You don't need much.) Then place the adapter into the wand opening. While applying gentle inward pressure, simply rock the adapter back and forth and it will seat itself in the device. Once the insert reaches the back of the wand, you can rock one further time to adjust adapter and make it perfectly straight. (as seen in these pictures).
The insert will remain in place till you want to remove it. Then it easily removes with a similar rocking motion, applying a gentle pulling as the insert is removed.
Easy to use. Easy to clean. Just easier!
DISCLAIMER: iSpire Wand, VapCaps (and table seen in photos) not included!